NXP公司的PCF2119x 是低功耗LCD控制器和驅動器,可以驅動2行16字符或1行32字符的點陣LCD顯示器,其功能包括片內LCD偏壓產生,和大多數MCU通過4位或8位總線或2線I2C總線來連接.主要應用在通信設備,手提儀器和POS終端.本文介紹了PCF2119x主要特性和優勢, 方框圖以及典型應用電路,和MCU連接方式.

PCF2119x: LCD controllers/drivers

The PCF2119x is a low power CMOS1 LCD controller and driver, designed to drive a dot matrix LCD display of 2-lines by 16 characters or 1-line by 32 characters with 5 × 8 dot format. All necessary functions for the display are provided in a single chip, including on-chip generation of LCD bias voltages, resulting in a minimum of external components and lower system current consumption. The PCF2119x interfaces to most microcontrollers via a 4-bit or 8-bit bus or via the 2-wire I2C-bus.

The chip contains a character generator and displays alphanumeric and kana (Japanese) characters.

The letter ‘x’ in PCF2119x characterizes the built-in character set. Various character sets can be manufactured on request. In addition 16 user defined symbols (5 × 8 dot format) are available.

PCF2119x主要特性和優勢:

Single-chip LCD controller and driver

2-line display of up to 16 characters plus 160 icons or 1-line display of up to 32 characters plus 160 icons

5 × 7 character format plus cursor; 5 × 8 for kana (Japanese) and user defined symbols

Reduced current consumption while displaying icons only

Icon blink function

On-chip:

Configurable 4, 3 or 2 times voltage multiplier generating LCD supply voltage, independent of VDD, programmable by instruction (external supply also possible)

Temperature compensation of on-chip generated VLCDOUT: −0.16 %/K to −0.24 %/K (programmable by instruction)

Generation of intermediate LCD bias voltages

Oscillator requires no external components (external clock also possible)

Display Data RAM (DDRAM): 80 characters

Character Generator ROM (CGROM): 240 characters (5 × 8)

Character Generator RAM (CGRAM): 16 characters (5 × 8); 4 characters used to drive 160 icons, 8 characters used if icon blink feature is used in application

4-bit or 8-bit parallel bus and 2-wire I2C-bus interface

Manufactured in silicon gate CMOS process

18 row and 80 column outputs

Multiplex rates 1:18 (2-line display or 1-line display), 1:9 (for 1-line display of up to 16 characters and 80 icons) and 1:2 (for icon only mode)Uses common 11 code instruction set (extended)

Logic supply voltage: VDD1 − VSS1 = 1.5 V to 5.5 V (chip may be driven with two battery cells)

LCD supply voltage: VLCDOUT − VSS2 = 2.2 V to 6.5 V

VLCD generator supply voltage: VDD2 − VSS2 = 2.2 V to 4 V and

VDD3 − VSS2 = 2.2 V to 4 V

Direct mode to save current consumption for icon mode and multiplex drive mode depending on VDD2 value and LCD liquid properties)

Very low current consumption (20 μA to 200 μA):

Icon mode: < 25 μA

Power-down mode: < 2 μA

Icon mode is used to save current. When only icons are displayed, a much lower operating voltage can be used and the switching frequency of the LCD outputs is reduced; in most applications it is possible to use VDD as LCD supply voltage

PCF2119x應用:

Telecom equipment

Portable instruments

Point-of-sale terminals

圖1.PCF2119x方框圖

圖2.PCF2119x采用并行接口,4位或8位總線的應用框圖

圖3.PCF2119x采用I2C總線接口的應用框圖

圖4.PCF2119x和2x16字符LCD的連接框圖

圖5.PCF2119x和1x32字符LCD的連接框圖
詳情請見:
http://www.nxp.com/documents/data_sheet/PCF2119X.pdf